This dragon is made from fabric specifically printed for my dragon pattern. It's not airbrushed - the fabric is printed this way at the factory. It's slightly shorter than the usual Shannon solids I use, but like other digital prints the under-fur is white and will show slightly on places like the horns and muzzle.
This little dragon is a reject, sadly: an early color test that didn't work out. It's not bad, per se - I was shooting for a shaded version of the "bronze" dragons I make from Shannon Minky in Rust, and I ended up with a foxy-looking dragon. I have also decided the pre-printed wing "fingers" are too hard to align, though that makes this one a rare dragon that also has them on the underside of its wings.
It's a little under three-and-a-half inches tall to the tip of its nose, with a wingspan around four inches.
Despite its toy-like appearance, this is an adult collectible with small parts that could pose a choking hazard. Made in a smoke-free but cat-occupied home from an original Silver Seams pattern. The seltzer can and other props are just for scale/comparison and not included in this listing. Any cat hair is also not included but will probably be sent to you despite my best efforts. You are buying one dragon.
Join my Patreon for monthly rewards!
Was my site helpful? Buy me a Ko-Fi!