An improvement to the notebook covers
One of the most annoying parts of making the mini composition book covers is getting the pockets to stay on the underside of the hoop. The edges like to hang up on the embroidery arm, the “grippier” vinyls like to dig in their heels and let the hoop go on without them, etc. I’ve come up with a solution that also saves on vinyl and bulk.
Rather than adding the pocket, I have started cutting two slots in the backing vinyl itself. Once the notebook is inserted, the raw embroidery back is hidden; if you don’t like it being visible through the slots, you can add an inner lining. A piece of decorative paper cut to fit just inside the topstitching line, or even another piece of stabilizer, will work.
I cut the slots before the topstitching, though if you’re brave and careful you could probably do it afterward. The slots need to be about 3″ apart, and about 4 3/8″ long (adjust it if you’re using a different notebook insert). I mark the four points and then use a small leather punch to cut circular holes, which I then carefully connect with a rotary cutter. Usually I finish the connection with scissors, because I don’t want to cut past the holes — part of the point of them is to stop the slots from tearing further at the ends.
When it’s time for the final topstitching, I make sure everything is squared up and temporarily put a bit of tape across the middle of each slot to keep it all flat during sewing. It sews much more smoothly, and I like the feel of the notebook covers better.
I’ve acquired quite a few more fun designs. These haven’t had the corners rounded yet. I’ll do that when my new corner chomper 📦 arrives. I’ve been trimming them by hand, but I’m hoping this will do a neater job.